Table of Contents
Advertisement
a.
From the normal display mode, press and release the
"OUT/+" key once to view the outdoor maximum
temperature and humidity ("MAX" will be displayed above
the outdoor temperature and humidity).
b. Press and release the "OUT/+" key again to view the outdoor
minimum temperature and humidity.
c.
Press and release the "OUT/+" key again to return to the
normal mode (timeout of viewing minimum/maximum values
will occur if no keys are pressed for fifteen seconds).
d. Note: To reset the outdoor minimum and maximum
temperature and humidity, first display the values you wish to
reset (minimum or maximum). Next press and hold the
"SET" key for at least three seconds. You will see then that
the values will reset to the current temperature and humidity
and corresponding time.
D. Multiple Remote Temperature Sensors
The WS-8035U-IT is able to receive signals from 2 additional thermo/hygro
sensors. The following are instructions for the set-up of remote thermo/hygro
sensor units with the WS-8035U-IT. These extra sensors can be purchased
through the same dealer as this unit.
1.
Remove all the batteries from the receiver and sensor(s) and wait 60
seconds. During these 60 seconds, press any button 20 times to discharge
any excess power.
2.
Insert the batteries to the first thermo/hygro sensor.
3.
Within 2 minutes of powering up the first sensor, insert the batteries to the
Weather Station. Once the batteries are in place, all segments of the LCD
will light up briefly. Following the indoor temperature and humidity, and the
time as 12:00 will be displayed. If they are not shown in LCD after 60
seconds, remove the batteries and wait for at least 60 seconds before
reinserting them.
4.
The outdoor temperature and humidity from the first sensor (channel 1)
should then be displayed on the Weather Station. If this does not happen
and the signal reception icon is not shown, after 2 minutes, the batteries will
need to be removed from both units and reset from step 1.
5.
Insert the batteries to the second sensor as soon as the outdoor
temperature and humidity readings from the first sensor are displayed on
the Weather Station.
NOTE: You must insert the batteries into the second sensor within 45
seconds of reception of the first sensor.
6.
The outdoor temperature and humidity from the second sensor and the
"channel 2" icon should then be displayed on the Weather Station. If this
does not happen after 2 minute, the batteries will need to be removed from
all the units and reset from step 1.
7.
Insert the batteries to the third sensor as soon as the "channel 2" icon and
outdoor data are displayed on the Weather Station. Then within 2 minutes,
the channel 3 outdoor data from the third sensor will be displayed and the
channel icon will shift back to "1" once the third sensor is successfully
received. If this is not happen, user shall restart the setting up from step 1.
15
Hide quick links:
Advertisement
Table of Contents
