Changing The Display Mode - La Crosse Technology WS-8248 Instruction Manual

433MHz RECEPTION CHECK FOR OUTDOOR TEMPERATURE TRANSMITTER
The atomic clock will receive the temperature data within 4 minutes. If the temperature data has not
been received 4 minutes after setting up (the display shows "- - -"), then please check the following
points:
1. The distance of the atomic clock or outdoor temperature transmitter should be at least 6 feet (2
meters) away from any interfering sources such as computer monitors or TV sets.
2. Avoid placing the receiver onto or in the immediate proximity of metal window frames.
3. Using other electrical products such as headphones or speakers operating on the same signal
frequency (433MHz) may prevent correct signal transmission and reception.
4. Neighbors using electrical devices operating on the 433MHz signal frequency can also cause
interference.
Note:
When the 433 MHz signal is received correctly, do not re-open the battery cover of either the outdoor
temperature transmitter or atomic clock, as the batteries may spring free from the contacts and force
a false reset. Should this happen accidentally then reset all units (see Setting up above) otherwise
transmission problems may occur.
The maximum transmission range is 330 feet (100 meters) from the outdoor temperature transmitter
to the atomic clock (in open space). However, this depends on the surrounding environment and
interference levels. If no reception is possible despite the observation of these factors, all system
units have to be reset (see Setting up).

CHANGING THE DISPLAY MODE

(SECONDS,TEMPERATURES AND HUMIDITY)
There are four possible display modes to view the seconds, temperatures and humidity.
The indoor humidity, indoor temperature and outdoor temperature display is the default (factory)
setting.
To change the display:
1. Press and release the + key. The display should now show the seconds, indoor temperature and
outdoor temperature.
2. Press and release the + key a second time. The display will now show the indoor humidity,
seconds and outdoor temperature.
3. Press and release the + key a third time. The display will now show the indoor humidity, indoor
temperature and seconds.