Drive Mounting; Figure 2. Alternate Capacity Jumper And Master/Slave Jumper - Seagate Medalist 17240 Product Manual

18 Medalist 17240, 13030, 10231, 8420 and 4310, Rev. B
Alternate capacity and master/slave
jumper settings
1.
The drive is shipped with a jumper on pins 7
and 8. This configures the drive for master or
single drive operation.
2. Consult your computer manual to determine
whether your computer supports cable select.
3. Use this jumper setting only if the drive does
not work with a jumper on pins 7 and 8.
4. Use this jumper setting if your computer fails
to boot because it cannot recognize drives with
more than 4,092 cylinders.

Figure 2. Alternate capacity jumper and master/slave jumper

2.3 Drive mounting

You can mount the drive in any orientation using four screws in the side-
mounting holes or four screws in the bottom-mounting holes. See Figure
3 for drive mounting dimensions.
Important mounting precautions:
•
Allow a minimum clearance of 0.030 inches (0.76 mm) around the
entire perimeter of the drive for cooling.
•
Use only 6-32 UNC mounting screws.
•
The screws should be inserted no more than 0.22 inch (5.58 mm) into
the bottom mounting holes and no more than 0.20 inch (5.0 mm) into
the side mounting holes.
•
Do not overtighten the mounting screws (maximum torque: 3 inch-lb,
0.34 N.m, 3.45 kgf.cm).
•
Do not use a drive interface cable more than 18 inches (457 mm) long.
ATA interface
connector
2 4 6
4-pin power
connector
1 3 5
Slave
1
Master or single drive
2
Enable cable select
Master with non-ATA
3
compatible slave
Limit capacity to 2.1 Gbytes
4
(4,092 cylinders)
8
7