3.4
Drive mounting
Users can mount the drive in any orientation using four screws in the side-mounting holes or four screws in the bottom-mounting holes.
See
Figure
4,
Figure 5
and
drive:
• Allow a minimum clearance of 0.030 in (0.76mm) around the entire perimeter of the drive for cooling.
• Use only 6-32 UNC mounting screws.
• The screws should be inserted no more than 0.140 in (3.56mm) into the bottom or side mounting holes.
• Do not overtighten the mounting screws (maximum torque: 6 in-lb).
3.4.1
Mechanical specifications
Refer to
Figure
4,
Figure 5
Weight:
10TB & 8TB models
6TB model
4TB model
2TB model
These dimensions conform to the Small Form Factor Standard documented in
Note
SFF-8301 and SFF-8323, found at
Figure 4.
Mounting configuration dimensions 5-disk models
Note
The image is for mechanical dimension reference only and may not represent the actual drive.
Seagate IronWolf Pro SATA Product Manual, Rev. A
Figure 6
for drive mounting dimensions. Follow these important mounting precautions when mounting the
and
Figure 6
for detailed mounting configuration dimensions.
www.snia.org
1.59 lb
720g
1.58 lb
716g
1.43 lb
650g
1.37 lb
620g
Section 3.4, "Drive mounting."
22