Sangean PR-D7 User Manual page 13

. The radio alarm can be set either radio is on or off.
2. Press and hold the radio alarm button
will show radio alarm symbol
3. Display Hour will flash, using Tuning up/Down button to select
the hour then press
4 Press the Tuning up/down button to select the desired minute and
press button to confirm minute setting.
5. While radio alarm symbol is flashing, press the Tuning up/down to
select desired wake-up band and station, then press
to confirm the selection. Radio alarm setting is now completed.
Active alarms are shown using alarm indicator on the display.
6. To cancel a sounding alarm, press the Standby button to cancel a
sounding alarm.
7. To cancel the radio alarm setting before the alarm sounds off,
press and hold the radio alarm button for 2 seconds (followed by
a beep).
Note:
If the signal of the set station cannot be found, the buzzer alarm
will be used instead.
followed by a beep.
button again to confirm hour setting.
for 2 seconds, the radio
GB
button
2