Using The Clock Radio For The First Time - Sangean RCR-3 User Manual

Using the clock radio for the first time

1. Place your clock radio on a flat surface.
2. Fully extend the wire aerial located on the rear of your clock radio.
Place the wire antenna so that it is straight as possible extending
either above or below the radio.
3. Insert the adaptor plug into the AC socket located on the rear of
your clock radio. The display will show "time zone" for a few
seconds and then the display will ask you to set your time zone.
To set the time zone, press the Tuning up/down button and the
Select button to confirm. The clock hands will then move to 12:00
and _ _: _ _ will show on the display. The radio will scan for signal
and if a signal is found and received completely it will then show
on the screen without flashing. Now the radio will show both
the current time and the clock hands will then move to show the
correct time.
4. If no signals are found,
be necessary to relocate your clock radio to a position giving
better reception.
IMPORTANT:
The mains adaptor is used as the means of connecting the clock
radio to the mains supply. The mains socket used for the clock
radio must remain accessible during normal use. In order to
disconnect the radio from the mains completely, the mains adaptor
should be removed from the mains socket outlet completely.
Characters appearing on the LCD display indicates the clock radio
is connected to and powered from the mains supply.
will be flashing on the display. It may
GB
7