Operating Your Radio - Sangean WR-22 User Manual

Operating your radio

Your radio is equipped with three tuning methods- Scan tuning,
manual tuning and memory preset tuning.
Scan tuning FM / AM
. Make sure you have set up the FM antenna in advance .
2. Press the On/Off button to switch on your radio.
3. Press the Source button repeatedly to select the desired wave
band.
4. Press the Tuning control rotary. Your radio will scan in an upwards
direction (low frequency to high frequency) and stop automatically
when it finds a station of sufficient strength.
5. After a few seconds the display will update. The display will show
the frequency of the signal found. If the signal is strong enough
and there is RDS / RBDS data present then the radio will display
the station name.
6. To find other stations, press the Tuning control rotary as before.
7. When the waveband end is reached your radio will recommence
tuning from the opposite waveband end.
8. Adjust the Volume buttons to the required setting.
9. To switch off your radio press the On/Off button.
GB