Speaker Connection - Xml410 - Samson XML Powered Owner's Manual

The XML410's power amplifier section can be configured to operate several ways, depending on the setting of the power
amp MODE switch located on the front panel. This allows you to choose whether you need MAIN plus MONITOR ampli-
fiers to power your speakers, or if you just need more power for the MAIN speakers.
There are three ways in which speakers can be connected to the XML410:
1) A single speaker can be connected to the output jack of AMP 1 and AMP 2,
2) Two speakers can be connected in parallel to the output jacks of AMP1 and AMP 2, or
3) A single speaker can be connected to the BRIDGE jack (bridge connection). For each of these situations, the required
speaker impedance will differ.
Refer to the following diagram, and make sure that the speaker impedance is not less than the specified value.
When connecting one speaker to AMP1
and one speaker to AMP 2, use speakers
with a 4–8 Ohm impedance rating.
Additional, or alternative amplifiers can be connected to the MAIN OUT and MONITOR OUT jacks on the front panel.
Owner's Manual

Speaker Connection - XML410

When connecting two speakers to AMP 1 and two speaker to
AMP 2, use speakers with an 8–16 Ohm impedance rating.
When the POWER AMPS
are in BRIDGE mode, use a
speaker with an 8–16 Ohm
impedance rating.
XML POWERED MIXERS
19