Speaker Connection - Xml610 & Xml910 - Samson XML Powered Owner's Manual

Speaker Connection - XML610 & XML910
The XML610 and XML910's power amplifier section can be configured to operate several ways depending on the set-
ting of the Power Amp MODE switch located on the front panel. This allows you to choose whether you need MAIN plus
MONITOR amplifiers to power your speakers, or if you just need more power for the MAIN speakers.
There are two ways in which speakers can be connected to the XML power mixer:
1) A single speaker can be connected to either the A or B jack of AMP 1 and AMP 2, or
2) Two speakers can be connected in parallel to both the A and B jacks of AMP1 and AMP 2.
For both of these situations, the required speaker impedance will differ. Refer to the following diagram, and make sure
that the speaker impedance is not less than the specified value.
When connecting one speaker to AMP1
and one speaker to AMP 2, use speakers
with a 4–8 Ohm impedance rating.
Additional, or alternative amplifiers can be connected to the MAIN OUT and MONITOR output jacks on the front panel.
Neutrik NL4 Speakon Wiring
18
When connecting two speakers to AMP 1 and two speaker to
AMP 2, use speakers with an 8–16 Ohm impedance rating.
XML POWERED MIXERS