Using An External Effect - Samson XML Powered Owner's Manual

Using an External Effect

Sending an Independent Mix to an External Effects Processor
If you prefer to use an external device for effects processing, you can easily connect the unit using the XML EFX bus. Fol-
low the steps below to interface your processor.
1. Set the MONITOR section MASTER control to the "0" position. Press the EFX BYPASS switch to disable the internal DSP.
2. Raise the AUX 2/EFX controls for the channels to which you want the external effect to be applied.
3. Adjust the EFX LEVEL to the "5" position.
4. Set the input level of the external effect so that the sound is not distorted, and so that the effect's input meter does not
indicate a clipped signal.
5. Connect the output of the external effect to an available input channel. Be sure to turn the AUX 2/EFX control for that
channel all the way down. Use the channel's VOLUME control to adjust the effect return level.
23
Owner's Manual XML POWERED MIXERS