Table of Contents
Advertisement
1.10 Connecting to Wired Network
Step 1 – Choose LAN Setting
Note: make sure LAN cable connecting to LAN socket already.
1. Press MENU
Turn SELECT to
2.
< System settings >, press
Turn SELECT to
3.
to < Network >, press
Turn SELECT
4.
to < Manual settings >, press
Turn SELECT
5. Highlight < Wired >, then press
6. Highlight < DHCP enable >, press
Step 2 – Enter Internet Radio mode
1. Press MENU 'Main menu', press
to confirm. Or, press MODE repeatedly until < Internet Radio > is showing up, then stop pressing.
Step3 – Access Network
Continue the above steps, few seconds later, it will show:
1.11 Shift to Wireless Network
1. Refer to previous page 'choose LAN setting' steps 1-4,
2. While highlighting < DHCP enable >, press
to access to wireless network.
Now, wireless setting is OK!
< Main Menu >, press
SELECT
to confirm.
SELECT
SELECT
to confirm.
SELECT
to confirm.
SELECT
to confirm, highlight 'Internet Radio', then press
SELECT
or
If it fails to connect to network, please follow:
a. Check your Router, see if it is working normally or not.
b. Check your LAN cable, make sure it wasn't been damaged,
c. See the port of cable which insert to LAN socket is touching well.
to confirm, and then do the step by step guide
SELECT
14
to confirm.
SELECT
to confirm.
to confirm.
The LAN setting is setup!
< Wireless >, press
turn SELECT to
SELECT
.
SELECT
Advertisement
Table of Contents
