KitchenAid GAS RANGE Installation Instructions Manual page 8

orifice spuds
etches
NAT
L.P.
gas
manifold
Remove and
L.R.
L.F. R.F. R.R.
5
n
Locate Natural gas orifice spuds in a
literature package included with the range.
Remove L.P. gas orifice spuds using a 3/8'
combination wrench. Install Natural gas orifice
spuds to replace the L.P. gas orifice spuds.
Place L.P. gas orifice spuds in plastic parts bag
for future use and keep with literature package.
Reinstall burners. Lower maintop to operating
position. Reinstall burner grates.
hood
L.P. gas
'decrease gas
decrease
flame size
pre-set at factory
for Natural gas
6
n
Oven burner: Use l/2' combination
wrench to loosen the orifice hood away from the
pin (approximately 2 to 2-l/2 turns). The burner
flame cannot be properly adjusted if this
conversion is not made.
7/
/
w Turn selector to the Natural position.
Allow enough time for the air to escape from the
pilot gas line. Check that the oven control knob is
in the "OFF" position. Remove oven control
knob. Light the pilot light.
8
H Complete installation sections D through
E, Pages 4-6. Check for proper flame. Natural gas
flames do not have yellow tips.
Page 7