To install the base plate on an LS-HB with a fixed anamorphic lens:
1. Place the projector upside down on a blanket or other soft surface.
2. Secure the base plate and Ceiling Mount Plate (if used) to the projector with the four,
M4 x 0.7 x 14mm screws provided with the anamorphic lens base plate.
1. Do not use the mounting screws provided with the ceiling
Caution
mounting kit. Use only the hardware provided with the
anamorphic lens base plate.
2. DO NOT OVER-TIGHTEN THE SCREWS.
1
Screw,
Phillips
Pan-Head,
M4 x 0.7 x
14mm (4x)
2
Anamorphic
Lens Base Plate
Figure 3-6. Projector with Fixed Anamorphic Lens Base Plate - Bottom View
Runco LS-HB/LS-HB Ultra Installation/Operation Manual
Ceiling Mount Plate
(part of Ceiling Mount Kit)
29
Installation
Installing the Fixed
Anamorphic Lens Base
Plate