QSC Q-SYS Core 3000 User Manual page 6

Q-Sys™ Core 1000 | Core 3000 | Core 4000 Panel Features
The image below shows the Q-Sys Core 1000, Core 3000 and Core 4000 front panel features for a product having a sample configuration of one blank
I/O Card.
Note that the Q-Sys hardware products are configured at the QSC factory per the customer's order. At the time of order, the customer specifies the
type of Q-Sys Audio I/O Card to be populated in rear panel audio I/O bay on the Q-Sys Core 1000, Core 3000 and Core 4000 products.
In addition, Q-Sys Audio I/O Card Kits are available for field installation by qualified service personnel.
1
Front Panel
1. SD Card Reader Socket
2. Audio I/O Signal and Card Present Indicators
3. 240 x 64 Monochrome Graphics LCD
4. Exhaust Vents
5. Next Page Navigation Button
10 14
11 12 13
Rear Panel
10. Audio I/O Bay – accepts optional Q-Sys audio I/O cards
11. RS-232 – DE-9 male connector for serial communications
12. Video Out – HD-15 female connector accepts diagnostic
VGA monitor
13. Auxiliary Ports
• AUX A Set – USB host connector x2, RJ45 10/100/1000 Mbps Ethernet
• AUX B Set – USB host connector x2, RJ45 10/100/1000 Mbps Ethernet
4 7 8
2 3 5 6 9
6. Device ID Button (locates device in Q-Sys Designer GUI)
7. Status LED (reports network health, ID and firmware update status)
8. Power On LED
9. Clear Settings Paperclip Button (resets network properties)
15 16
17
14. GPIO A and GPIO B – female DA-15 connectors for Q-Sys control I/O
15. Q-Sys Network Port
• LAN A – 1000 Mbps only, primary connection to Q-Sys gigabit network
• LAN B – 1000 Mbps only, backup connection to Q-Sys gigabit network
16. Reserved for Future Use
17. AC Main Inlet – IEC male connector
9
Q-Sys™ I/O Frame Panel Features
The images below show the Q-Sys I/O Frame front and rear panel features for a product having a sample configuration of two Mic / Line Input Cards
and two DataPort I/O Cards.
Note that the Q-Sys hardware products are configured at the QSC factory per the customer's order. At the time of order, the customer specifies the
type of Q-Sys Audio I/O Card to be populated in each of the four rear panel audio I/O bays on the Q-Sys I/O Frame.
In addition, Q-Sys Audio I/O Card Kits are available for field installation by qualified service personnel.
1
Front Panel
1. Fan Exhaust Vents
2. Audio I/O Signal and Card Present Indicators
3. 240 x 64 Monochrome Graphics LCD
4. Next Page Navigation Button
9
Rear Panel
9. Configurable Audio I/O Bays
10. GPIO Interface (control I/O) (see Page 12)
11. RS-232 Serial Control Interface
7
3
2 4 5 6
5. Device ID Button (locates device in GUI)
6. Reset Network Properties Paperclip Button
7. Status LED (reports network health, ID and firmware update status)
8. Power On LED
13
10 11 12
12. Dual Gigabit Network Interfaces for Q-Sys LANs
13. AC Main Inlet – IEC male connector
10
8