Icom IC-910H Instruction Manual page 37

D Manual repeater setting
q Set the desired frequency.
• Push [M/S•BAND] to select the desired band if required.
• Push [FM] to select FM mode if required.
w Push [SPLIT•DUP] for 1 sec. to select the duplex
operation and the shift direction.
• "DUP–" or "DUP+" indicator appears, depending on the
selection.
• Set the offset frequency in the FM set mode, if required.
D Using the one-touch repeater function
(except Europe, Sweden and Italy versions)
By using the pre-programmed offset frequency, shift
direction and tone frequency, quick and simple repeat-
er operation can be made.
The default values for offset frequency and direction
are as follows:
144 MHz band : –0.600 MHz
430(440) MHz band : –5.000 MHz
1200 MHz band : –20.000 MHz (optional)
Tone frequency : 88.5 Hz
q Push [M/S•BAND] to select the desired frequency
band.
w Push [FM] to select FM mode.
e Rotate the tuning dial to input the desired repeater
frequency.
• Direct frequency input using the keypad can be used for
frequency setting.
FM
D Setting tone frequency
(except Europe, Sweden and Italy versions)
q Push [M/S•BAND] to select the desired frequency
band.
w Push [SET] then [FM] to enter the FM set mode.
e Push [DN Z] or [Y UP] to select the tone frequency
item.
• "ton," selected band (144/430(440)/1200) and "T" indica-
tor appear.
r Rotate the tuning dial to set the desired tone fre-
quency.
t Push [FM] to exit from the FM set mode.
e Push [TONE] to activate the tone encoder.
• "T" indicator appears.
• Set the tone frequency in the FM set mode, if required
for non-European versions..
• 1750 Hz tone is transmitted for Europe, Sweden and
Italy versions.
r Push [SPLIT•DUP] for 1 sec. and [TONE] to cancel
the duplex operation and deactivate the tone en-
coder.
• "DUP–" or "DUP+" and "T" indicators disappear.
r Push [FM] to select the repeater operation mode.
• "DUP–" and "T" indicators appear.
t Push [PTT] to access the repeater.
y Release [PTT] to receive a signal from the repeater.
u Push [FM] to cancel the duplex operation mode.
• "DUP–" and "T" indicators disappear.
VFO A
D Setting offset frequency
q Push [M/S•BAND] or [SUB] to select the desired
frequency band.
w Push [SET] then [FM] to enter the FM set mode.
e Push [DN Z] or [Y UP] to select the offset frequen-
cy item.
• "duP" and selected band (144/430(440)/1200) appear.
r Rotate the tuning dial to set the desired tone fre-
quency.
t Push [FM] to exit from the FM set mode.
RECEIVE AND TRANSMIT
FM DUP
T
Shifts 5 MHz when transmitted.
FM DUP
T
S 1 3 5 7 9 20 40 60dB
FM
5
VFO A
VFO A
VFO A
35