Installation - Rockford Fosgate RFX8310 Installation & Operation Manual

S U
OURCE NIT
Source Unit Mounting Angle
• Mount the Source Unit as
close to horizontal as possible
for optimum CD Player
performance
• Mounting Angles up to ±20˚
from horizontal can be
accommodated
Using the Installation Sleeve - Standard Mount
• Mount the Installation Sleeve into a secure instrument panel
• Bend Tabs on the installation sleeve which correspond to the
chart above
• Bend Appropriate Tabs on all sides of the mounting sleeve
(Top, Bottom, Left & Right)
I
NSTALLATION
– 18 –
Installing the Source Unit – Standard Mount
CAUTION: Installation sleeve should be installed using the
appropriate tabs (refer to previous page)
• Install Source Unit by sliding unit into installation sleeve until
it clicks into place
• Mount Backstrap securely behind the instrument panel to
prevent source unit vibration
• Backstrap Screw should be 6mm max (use supplied screw)
• Connect Antenna to antenna jack on rear of source unit
• Antenna Ground should read less than 0.05
antenna and chassis ground
Installing the Source Unit – ISO-DIN Mount
• Remove Trim Piece and Installation Sleeve from source unit
• Factory Bracket should align with two mounting holes on
each side of source unit
• ISO Screws should be 6mm max (use supplied screws)
• Connect Antenna to antenna jack on rear of source unit
• Antenna Ground should read less than 0.05
antenna and chassis ground
• Install Source Unit into instrument panel
between
between
– 19 –