Configuring The Hdspe Madi Fx; Settings Dialog - RME Audio HDSPe MADI FX User Manual

11. Configuring the HDSPe MADI FX

11.1 Settings Dialog

Configuration of the HDSPe MADI FX is done via its own settings dialog. The panel 'Settings'
can be opened:
• by clicking on the hammer symbol in the Task Bar's notification area
The mixer of the HDSPe MADI FX (TotalMix) can be opened:
• by clicking on the mixer icon in the Task Bar's notification area
The HDSPe hardware offers a number of helpful, well thought-of practical functions and options
which affect how the card operates - it can be configured to suit many different requirements.
The following is available in the 'Settings' dialog:
• Latency
• Current sample rate
• Synchronization behaviour
• Configuration of digital I/Os
• Input selection
• State of input and output
Any changes made in the Settings
dialog are applied immediately -
confirmation (e.g. by clicking on OK or
exiting the dialog) is not required.
However, settings should not be
changed during playback or record if it
can be avoided, as this can cause
unwanted noises.
Also, please note that even in 'Stop'
mode, several programs keep the
recording and playback devices open,
which means that any new settings
might not be applied immediately.
The status displays at the bottom of
the dialog box give the user precise
information about the current status of
the system, and the status of all digital
signals.
The tab About includes information
about the current driver and firmware
version of the HDSPe MADI FX.
User's Guide HDSPe MADI FX © RME
14