Using The Miterfast Tool - Festool Kapex KS 120 User Manual

Using the MiterFast Tool

The MiterFast™ angle transfer tool converts a corner angle
measurement into a miter setting. The miter line in the
center of the tool is always at the midpoint of the two
angle arms, and when lined up with the saw's laser,
provides the proper miter angle for the measured corner.
Measure the Corner
For measuring an outside corner, extend the extension
►
arms as shown in the image below.
For measuring an inside corner, retract the extension
►
arms as shown in the second image below.
Loosen the lock knob on the MiterFast tool.
1.
Place the MiterFast tool in (or on) the corner and slide
2.
the lock knob forward to expand the arms.
When the arms are lined up with the corner walls,
3.
retighten the lock knob.
Supplemental User's Manual
Place the MiterFast tool on the saw with one of the
4.
arms up against the fence.
Turn on the laser for the saw. (Refer to
5.
Guides on page 11.)
Adjust the miter angle of the saw (refer to
6.
Miter Angle on page 12) until either of the laser beams
line up with the miter line on the MiterFast tool.
Lock the miter setting on the saw.
7.
Fold up the MiterFast tool and return it to its storage
8.
position in the base of the saw.
Using the Laser
Setting the
15