Honda Marine BF25D Owner's Manual page 90
Hide thumbs
Also See for Marine BF25D:
- Owner's manual (166 pages) ,
- Cleaning instructions (2 pages) ,
- Owner's manual (127 pages)
Table of Contents
Advertisement
CLEANING AND FLUSHING
WATER INTAKES
3.
Cover the three water intakes with
duct tape as shown above.
88
GARDEN HOSE ADAPTER
(FLUSH KIT COUPLER)
4.
Remove the sealing washer from
the wash screw and install the
sealing washer on the flush kit
coupler.
5.
Install the flush kit coupler into the
WASH screw hole and connect a
fresh water hose to the garden
hose adapter.
6.
Move the gearshift lever or control
lever to the N (neutral) position.
Flush the outboard motor in the
neutral position only.
7.
Turn on the fresh water supply to
the flush kit coupler.
Running the engine without good
water circulation can cause
overheating and water pump
damage.
Damage caused by running the
outboard motor without sufficient
cooling water is not covered by the
Distributor's Limited Warranty
(p.
120
).
COOLING SYSTEM INDICATOR
8.
Start the engine. Monitor the
cooling system indicator. Stop the
engine if water does not come out
of the cooling system indicator and
check the fresh water supply.
Advertisement
Table of Contents
