Connection And Preparation; Connecting The Headphones; Connecting The Power Cord; Inserting Batteries In The Remote Control - Grundig CDS 7000 DEC Manual

CDS_7000_ DEC_en 21.05.2007
14
14:49 Uhr Seite 14

CONNECTION AND PREPARATION

Connecting the headphones

Insert the headphone plug (ø 3,5 mm) into the » « socket on
1
the left side of the hi-fi.
– The loudspeakers of the hi-fi system are switched off.

Connecting the power cord

Note:
Check that the mains voltage on the type plate (on the back of
the hi-fi system) corresponds to your local mains supply.
The only way to disconnect the hi-fi system from the mains sup-
ply is to pull the plug.
Plug the mains cable supplied into the
1
fi system.
2 Plug the power cord into the wall socket.

Inserting batteries in the remote control

1 Open the battery compartment by turning its lid.
When inserting the batteries (2 x 1.5 V, R 6/UM 4/AAA),
2
observe the polarity marked on the base of the battery com-
partment.
Note:
If your hi-fi system no longer reacts properly to remote control
commands, the batteries may be flat. Always remove used bat-
teries. The manufacturer accepts no liability for damage result-
ing from leaking batteries.
Environmental note:
Batteries, including those which contain no heavy metal, should
not be disposed of with household waste. Please dispose of
used batteries in an environmentally responsible manner. Find
out about the legal regulations which apply in your area.
»AC ~« socket on the hi-
_