Jointer; V-Belt - Grizzly G0604X EXTREME SERIES Manual Insert

Jointer

Components and Hardware Needed:
Jointer Assembly ............................................... 1
Stand Assembly w/Motor ................................... 1
Cap Screws M8-1.25 x 25 ................................. 4
Lock Washers 8mm ........................................... 4
The jointer is heavy. Seek
assistance when lifting it
onto the jointer stand.
To mount the jointer to the stand:
1. Remove the rear cover from the jointer
stand.
2. With the help of an assistant, lift the jointer
onto the stand.
3. Align the mounting holes on the jointer and
stand.
4. Secure the jointer to the stand with the cap
screws and washers as shown in Figure 6.
Figure 6. Securing jointer to stand.
-14-
Qty Components and Hardware Needed:

V-Belt ................................................................. 1

Belt Guard ......................................................... 1
Flange Bolts M6-1 x 12 ..................................... 2
Hex Nuts 6mm ................................................... 2
Flat Washers 6mm ............................................ 2
To install the V-belt:
1. Loosen the motor bracket fasteners shown in
Figure 7.
Figure 7. Motor bracket fasteners (black arrows);
motor mount fasteners (white arrows).
2. Slide the motor upward and place the V-belt
around the cutterhead pulley and the motor
pulley.
3. Slide the motor down to tension the V-belt.
4. Visually check the alignment of the two pul-
leys to make sure that they are aligned and
that the V-belt is straight up and down (see
Figure 8).
— If the pulleys are aligned, tighten the motor
bracket fasteners and go to Step 8.
— If the pulleys are NOT aligned, perform
Steps 5–7.
V-Belt
G0604 6" X 56" Jointer
Qty