Table of Contents
Advertisement
5.
to remove the v-belts from the roller pulley,
the roller needs to be removed. open the
left-hand access door and remove the platen
micro-adjust knob by loosening the setscrew
that secures the face. the plate underneath
the knob is secured to the casting by two
setscrews—remove these. figure 35 shows
the knob and indicator plate removed from
the casting.
6.
remove the large cap screws, also shown in
figure 35, to loosen the casting on the roller
shafts.
figure 35. remove platen adjustment knob,
indicator plate, and large cap screws.
7.
Work the casting off the roller shafts as
shown in figure 36.
figure 36. Work the casting off the roller shafts.
-36-
8.
open the right-hand access door and locate
the large nut shown in figure 37 and remove
it with the box wrench included with the
machine.
figure 37. remove this roller shaft nut located
behind right-hand access door.
9.
slide out the front roller shaft, as shown in
figure 38, to get the v-belts off of the pul-
ley.
figure 38. remove roller.
10. installation is the reverse of removal. if
possible, have an assistant help you when
installing the v-belts and the roller. also, an
assistant can be helpful on the other end of
the roller when tightening the nuts on the
roller shafts.
Model G9983 (Mfg. Since 8/09)
Advertisement
Table of Contents
