Amplifier Controls; Sound Quality Optimization - Goldmund METIS 3 User Manual

5

AMPLIFIER CONTROLS

On the front plate of the Goldmund Metis 3 Amplifier you will find only one switch used
to power the amplifier ON and one power LED.
When turned ON the 2 channels are connected after a few seconds and the front panel
"POWER" LED lights up.
The amplifier may be powered OFF by turning off the "POWER" switch at any time. The
LED will fade very slowly, indicating discharge of the filter capacitors. The speakers will
be disconnected almost immediately.
6

SOUND QUALITY OPTIMIZATION

Warm- - - - up sonic effect Warm Warm Warm up sonic effect up sonic effect up sonic effect
If the power amplifier has not been powered on for a few days, the optimum sound
quality is reached after 15 minutes. This delay has been optimized to be minimal and the
sonic quality when just powered on is much higher than other quality power amplifiers.
GOLDMUND METIS 3 – ANALOG POWER AMPLIFIER - 7