Qlogic Fibre Channel Adapter User Manual page 40

Troubleshooting
Troubleshooting with Driver Logs
Table A-6. Common Driver Log Messages (Continued)
"%s(): **** CMD derives a NULL HA\n"
Indicates the command does not point to an adapter structure.
"%s(): **** CMD derives a NULL search HA\n"
Indicates the command does not point to the adapter structure.
"scsi(%ld:%d:%d:%d): now issue ADAPTER RESET.\n"
Indicates an adapter reset is being issued to (host:bus:target:lun).
"scsi(%d): Unknown status detected %x-%x"
Indicates the status returned from the firmware is not supported. %x-%x is the completion-scsi
statuses.
"scsi(%ld:%d:%d:%d): Enabled tagged queuing, queue depth %d.\n"
Indicates the queue depth for the (host:bus:target:lun).
"PCI cache line size set incorrectly (%d bytes) by BIOS/FW,"
Indicates a correction in the cache size. %d is the cache size.
"scsi(%d): Cable is unplugged..."
Indicates the firmware state is in LOSS OF SYNC; therefore, the cable must be missing.
"qla2x00: Performing ISP error recovery - ha=%p."
Indicates the driver has started performing an adapter reset.
"qla2x00_abort_isp(%d): **** FAILED ****"
Indicates the driver failed performing an adapter reset.
"%s(%ld): RISC paused, dumping HCCR (%x) and schedule an ISP abort (big-ham-
mer)\n"
Indicates the driver has detected the RISC in the pause state.
"scsi(%ld): Mid-layer underflow detected (%x of %x bytes) wanted "%x
bytes...returning DID_ERROR status!\n"
Indicates an underflow was detected.
"%s(): Ran out of paths - pid %d"
Indicates there are no more paths to try for the request. %s is the function name and %d is the mid-level
processor identifier (PID).
"WARNING %s(%d):ERROR Get host loop ID"
Firmware failed to return the adapter loop ID.
A-8
S
FC0054606-00 A