Simple Network Management Protocol; Snmp Parameters - Qlogic iSR6200 Software Manual

B
Simple Network
Management Protocol
Simple network management protocol (SNMP) provides monitoring and trap
functions for managing the router through third-party applications that support
SNMP. The router firmware supports SNMP versions 1 and 2 and a QLogic
management information base (MIB). You may format traps using SNMP version
1 or 2.
This appendix provides the following SNMP information for the iSR6200 data
migration:
"SNMP Parameters" on page B-1
"SNMP Trap Configuration" on page B-2
"Notifications" on page B-2

SNMP Parameters

You can set the SNMP properties using SANsurfer iSCSI/FC Router Manager or
the CLI.
Table B-1
Parameter
Read community
Trap community
ISR654608-00 B
describes the SNMP parameters.
Table B-1. SNMP Parameters
A password that authorizes an SNMP management server to read information
from the router. This is a write-only field. The value on the router and the SNMP
management server must be the same. The read community password can be
up to 32 characters, excluding the number sign (#), semicolon (;), and comma
(,). The default is password is private.
A password that authorizes an SNMP management server to receive traps. This
is a write-only field. The value on the router and the SNMP management server
must be the same. The trap community password can be up to 32 characters,
excluding the number sign (#), semicolon (;), and comma (,). The default pass-
word is private.
Description
B-1