Table of Contents
Advertisement
TOC
Distance from edge of
media to edge of
thru-hole
Reflective/Black
Mark Width*
Max Outer Diameter (OD) 5.0" (127mm)
Inner Core Diameter (ID)
Stock Thickness
Distance from edge of
label to edge of liner
* The Reflective/Black Mark should be opaque to infared light.
The mark should be between the labels. The end of the mark
should correspond with the beginning of the label.
Roll Specifications
Label Side Out
Roll O.D.
Core I.D.
Core O.D.
Notes:
1. Label height <1.5" requires a 2.00" I.D. x 3.00" O.D. core.
Label height >1.5" requires a 2.00" I.D. x 2.25" O.D. core.
2. Turret glue or 1/2"-wide 3M 928 double-sided removable tape must be
used to attach stock to core. Removable tape must be positioned across
full width of core. Other types of tape are not allowed.
3. End face of liner must align with end of core on both sides within 0.030".
(Core width should be the same as liner width.)
4. Masking tape or equivalent may be used to secure label stock to outside of roll.
Max
1.90" (48.3mm)
Equal to distance 0.10" (2.5mm)
between labels
see roll specifications below
0.006"
(152 micron)
Printer driver assumes 2 mm gap.
However, this is adjustable via the
left margin
Media Roll
Media and Roll Specifications
INDEX
Min
0.20" (5.1mm)
N/A
N/A
offset.
2"
5"
31
Advertisement
Table of Contents
