Table of Contents
Advertisement
TOC
Details/Print Counter
Clicking on the Details button will allow you to view
information about printer settings stored in the printer.
There is also a Print Counter in the details window to help
you count the number of prints printed since the last time it
was reset. Click Reset Counter to set the counter to zero.
The Restore Factory Defaults button will restore the printer set-
tings displayed on the details window to factory calibrated
defaults.
Sensor Type
Sensor Type refers to the method the printer will use to detect
the print starting position for each image. If you are using
standard die-cut labels or Through-hole label material where
holes in the stock are used for alignment purposes, use the
Die-Cut/Thru-Hole setting. Use Reflective for timing mark
sensing label material where a pre-printed line on the back of
the media indicates the break between labels. If you have
continuous stock with no die-cut, reflective mark, or holes, set
the sensor type to Continuous Feed. This will turn off the
media sensor during printing. This is the default setting.
Important Note: Die-cut media is not recommended.
Printer Settings
18
INDEX
Advertisement
Table of Contents
