Table of Contents
Advertisement
TOC
Offsets - Cut Position:
With this setting you can fine-tune the cut position after the
image prints. Increase this value to move the media further out
before the cut; decrease this value to eject the stock less before
the cut. The unit of measure is is 0.1mm.
Note: Every one-hundred cuts the cutter will cut twice (one cut, one cycle)
to clean the blades.
Note: If you are using Primera wristband stock the default Cut Position is
set so that you do not cut through the adhesive portion of the the
stock. If you adjust the Cut Position be make sure that it is not
adjusted so that it cuts through the adhesive.
Using the Integrated Cutter
INDEX
13
Advertisement
Table of Contents
