Primera PX450 User Manual page 24

TOC
Left Margin Offset
This will be factory calibrated. If fine-tuning is needed,
increase this setting to move the image right on the media;
decrease this setting to move the image to the left on the
media. The unit of measure is 0.1mm.
Top of Form (TOF)
This setting allows you to fine-tune the image starting position
on your media. This will be factory calibrated. If fine tuning
is needed, increase this value to move the image down on the
media. Decrease this value to move the image up the media.
The unit of measure is 0.1mm.
Click the Test button to send a test
print to the printer that will help
you adjust the TOF and Left Margin
Offset. The printer will print the
pattern shown. Adjust the values
so that both black bars print on the
label with no white space on the
label and no ink on the metal plate
supporting the media.
Cut Position
With this setting you can fine tune the cut position after the
image prints. Increase this value to move the paper further out
before the cut; decrease this value to eject the media less before
the cut. The unit of measure is is 0.1mm.
Printer Settings
20
INDEX
-
+
LEFT OFFSET
(10 units)
1.0 mm
TOF
+
-