Precor C954 Owner's Manual page 15

C O M M E R C
Diagram 6 Attach the
console to the
left upright
support.
Buttonhead
screws
10. Secure the display console to the left upright support. Diagram 6. Align
the mounting holes on the console to those on the left upright support.
Insert 2 screws (A) and washers (B). Do not securely tighten the screws
until after the handrails have been attached.
Important: With the handrails attached, the width of the treadmill is 36.75"
(93 cm). It will not fit through a standard 36" doorway.
11. Attach the handrails. Diagrams 7 and 8. For ease of assembly, place the
side rails or rear feet on blocks. Obtain assistance to lift the treadmill. Do
not place blocks beneath the running bed.
To attach the handrails, perform the following steps on one side at a time :
Diagram 7 Handrail alignment and installation.
a. Alignment pins on the top of the handrails necessitate sliding the hand-
rails into the console assembly at an approximate 45 angle. Position the
handrail as shown in Diagram 7 and slide it onto the console extension.
When the alignment pins are fully engaged, carefully lower the handrail
toward the base. Insert 2 screws (C) and finger-tighten.
I A L P R O D
1
U C T S D I V
2
3
I S I O N
Console
extension
page 15