Setup Menu; Auto Search - Zenith SENTRY 2 SLS2555S5 Operating Manual And Warranty

SETUP MENU
--> AUTO SEARCH
FAV. CHANNELS I
BAND SELECT |
AFC MODE |
TIME SET )
I I
AUTO SEARCH CH2
PRESS ADJUST SAVED
KEY TO START
PRESS ADJUST
KEY TO CHANGE
Auto Search Display Fav. Channels Display
I BANDSELECF 1
BROADCAST
PRESS ADJUST
KEY TO CHANGE
Band Select Display
i
I !
iooo 1
PRESS ADJUST PRESS NUMBERS
KEY TO CHANGE OR ADJUST KEYS
AFC Mode Display Time Set Display
AUTO SEARCH
Purpose
Finds all available channels and stores them in memory for
access by CHANNEL (CH) Up/Down.
Use AUTO SEARCH only when you first install your TV,
or when you permanently change the connections to the
TV. For example, when you replace the antenna with a
cable-TV system.
Programmed channels are stored in protected memory, and
are not affected
by
a power
outage.
Before Using AUTO SEARCH
Connect and turn ON all external equipment, such as cable
TV decoder, VCR, etc.
- > AUTO'SEARCH
FAV. CHANNEI_
BAND SELECT
AFC MODE
TIME SET
Selecting Auto Search
AUTO SEARCH
PRESS ADJUST
KEY TO START
Auto Search Display
AUTO SEARCH
SEARCHING ....
CH2
While Searching for
Active Channels
2597-O
v_.?-on Search is
Complete
To Use AUTO SEARCH
1. AUTO SEARCH display should be shown on the
TV if you followed the "Basic Menu Operation"
given in the "On-Screen Menus" section.
2.Press ADJUST (ADJ) Left/Right to start the
AUTO SEARCH, the status of the search is shown
in the display. When the search is complete, you can
watch the TV program of your choice.
When Some Channels Are Not Found
AUTO SEARCH finds
only
active channels and stores
them in the Favorite Channel memory. You can add chan-
nels to those stored in memory by using the FAV.
(Favorite) CHANNELS option.
If you have difficulty tuning some channels, you may have to
manually change the BAND SELECT and AFC MODE.
Refer to respective option for details.
When Only AUX Channel is Found
You may have used AUTO SEARCH without having a sig-
nal source (antenna, cable-TV, etc...) connected to the TV.
In which case, no channels are stored in Favorite Channel
memory, and the TV operates only on the AUX channel.
To resolve this condition, connect a signal source, turn fig-
hal source ON, if needed, and use AUTO SEARCH again.
NOTE: AUX (Auxiliary) channel is operational only on
TVs having separate video and audio inputs for VCR opera-
tions.
J
8--1