Setup Menu; Auto Ch. (Channel) Search - Zenith SENTRY 2 SLS2751Y Operating Manual And Warranty

SETUP MENU
SETUP MENU SETUP MENU
-_ AUTO CH. SEARCH
CH. ADD/DEL
CH. LABELS *
TUNING BAND
AUTO FINE TUNE
CLOCK SET
CAP11ONS
CH. BACKGROUND
START
SETUP Menu
* Some models CLOCK SET
CAPTIONS
CH. BACKGROUND
SETUP Menu While AUX Channel is Being Used
(To get SETUP Menu on left, select a regular channel)
AUTO CH. (Channel) SEARCH
Purpose
Finds all available channels and stores them in memory for
access by CHANNEL (CH) Up/Down.
Use AUTO CH. SEARCH only when you first install your
TV, or when you permanently change the connections to
the TV. For example, when you replace the antenna with a
cable-TV system.
Programmed channels are stored in protected memory, and
are not affected by a power outage.
Before Using AUTO CH. SEARCH
Connect and turn ON all external equipment, such as cable
TV decoder, VCR, etc.
NOTE: AUTO CH. SEARCH is not displayed while AUX
channel is being used.
To Use AUTO SEARCH
1. AUTO CH. SEARCH should be selected if you
followed the "Basic Menu Operation" given in the
"On-Screen Menus" section.
2. Press ADJUST (ADJ) Left/Right to start the
AUTO CH. SEARCH, the status of the search is
shown in the display. When the search is complete,
you can watch the TV program of 'our choice.
When Some Channels Are Not Found
AUTO CH. SEARCH finds only active channels and stores
them in the favorite channel memory. You can add channels to
those stored in memory by using the CH. ADD/DEL option.
If you have difficulty tuning some channels, you may have to
manually change the TUNING BAND and AUTO FINE
TUNE. Refer to respective option for details.
NOTE: If signal source is a cable-TV decoder, the only
channel found will be 3 or 4.
When Only AUX Channel is Found
You may have used AUTO CH. SEARCH without having a
signal source (antenna, cable-TV, etc.) connected to the TV.
In which case, no channels are stored in the favorite channel
memory, and the TV operates only on the AUX channel.
To resolve this condition, connect a signal source, turn signal
source ON, if needed, and use AUTO CH. SEARCH again.
SETUP MENU
-> AUTO CH. SEARCH
CH. ADD/DEL
CH. LABELS
TUNING BAND
AUTO FINE TUNE
CLOCK SET
CAPTIONS
CH. BACKGROUND
START
DETERMINING TUNING BAND
Determining
Tuning Band
Selecting Auto Ch. Search
f
TUNING BAND IS
CH F---I lS FOUND
J
While Searching for
Active Channels
&LrID CH. SEARCH HAS OOMPI.ETEE
TUNING BAND IS
["_CHANNELS FOUND
When Search is
Complete
===._
CH 2
STEREO
When Returning to
Channel/Audio Display
2598-B 7 -- 1