Table of Contents
Advertisement
OPERATING YOUR TV
BASIC TV OPERATIONS
Selecting Channels by Using CHANNEL (CH) Up/Down
(All Models): You may select a channel through channel scan-
ning by using CHANNEL (CH)
Up/Down.
Only channels
stored in the channel scan sequence can be selected.
Selecting Channels
by Using Numbers on Remote (Select
Models): Press the numbers corresponding
to the channel
desired, then press ENTER (ENT). Any channel in the
band chosen can be selected through direct number entry.
FLSHBK (Flashback)
on Remote (Select Models): Press
FLSHBK to return to the last TV channel you were watch-
Adjusting Volume (All Models): You can adjust the volume
of your TV by using VOLUME (VOL) Up/Down.
Muting Volume (Select Models): To mute the sound com-
ing from your TV, press MUTE on the remote control. To
restore sound, press MUTE again.
After an Extended Power Outage (All Models): If you pre-
viously used AUTO CH. SEARCH, you do not have to use
it again unless you permanently changed the connections to
the TV. All of the channels previously found are stored in
protected memory, and are not affected by a power outage.
However, the clock must be reset to the current time.
C'H 2
10".56
CH2
10:56
MLrI_D
Channel/Time
Display
J
ChanvLelFI'imeDisplay
Whil,e TV is Muted
#
:VOL
\
Volume Display *
MUTED
Mute ]Display *
*
VOL or MUTE display is shown only
when captions are not being displayed.
EARPHONE
JACK (Select Models)
The earphone jack is used to connect a private listening ear-
phone (optional item) to your TV set. When the earphone
is plugged in, the TV speaker is turned off. This permits you
to enjoy TV programs without disturbing others in the area.
Any earphone having an 8-ohrn impedance and terminated
in a 35ram (1/8") subminiature
plug may be used. You may
purchase an earphone from your dealer.
CAUTION: When using the earphone, we suggest that you
set the volume on the TV to a low level before putting the
earphone ill your ear. Then adjust the volume to a comfort-
able listening level.
SLEEP TIMER
(Select
Models)
Some remote controls are equipped with a TIMER button
that provides access to the SLEEP TIMER available with
some TV faodels. By using the SLEEP TIMER, you can
program the TV to automatically shut off after a 15 minute
period up to 4 hours.
To Set SLEEP TIMER
1. Press TIMER
to see status
display.
2. Press
TIMER
repeatedly
until you reach
desired
shut-off
time.
One minute before the TV shuts off, the GOOD NIGHT
display appears on the screen. At this time you have a
choice of the following three actions.
1. Do nothing.
The TV will shut off in one minute.
2. Remove
the GOOD
NIGHT
display
by pressing
ENTER
(ENT).
The TV will still shut off in one
minute.
3. Delay the shut off by using TIMER
to select a new
shut off time.
To Cancel the SLEEP TIMER
You can cancel the SLEEP TIMER by setting the SLEEP
TIMER status to OFF.
NOTE: The SLEEP TIMFR
resets to OFF when you turn
off the TV.
SLEEP TIMER
0:15
PRESS TIMER
KEY TO CHANGE
Sleep Timer Display
GOOD
NIGHT
"Good Night" Display
z573-^
3 -- 1
Advertisement
Table of Contents
