Watching Tv Through Vcr; Vcr Is Turnedoff; Vcr Is Turned On And You Want To Select Channels At Tv; Vcr Is Turned On And You Want To Select Channels At Vcr - Zenith VR4156 Owner's Manual

WATCHING TV THROUGH VCR
Cable 1V
Wall Jack
From
Cable-TV
System
All-Channel
Antenna _ 7
Or
Direct Cable
=>.-
Zenith
Stereo MCR
Typical I CHANNELI3_---'--]4
I
Cable Box
I OUT
I
I
r' k_J OUT OUT I
Cable Box IN
to VCR
Block Diagram of Typical Video System
Zenith TV
]11
VCR Output to TV
(Channel 3 or 4 when
VCR is on and TV/VCR
is in VCR position)
Audio/Video Output to TV
VHF-UHF
CABLE IN
VIDEO AUDIO
IN IN
'1 I
VCR is Turned Off
1. Turn TV on.
2.
Select channel to be watched at TV. If you have a cable
box, select the cable box output channel (usually 3 or 4)
at the TV. Cable box channels are selected at the cable
box.
•
2.
VCR Is Turned On and You Want to Select
Channels at TV
Turn TV and VCR on.
|
Place VCR in TV mode by pressing TV/VCR switch on
remote control repeatedly until the [VCRI symbol disap-
pears from the VCR front panel.
Select channel to be watched at TV. If you have a cable
box, select the cable output channel (usually 3 or 4) at
the TV. Cable box channels are selected at the cable
box.
VCR Is Turned On and You Want to Select
Channels at VCR
1. Turn TV and VCR on.
2, Place VCR in VCR mode by pressing TV/VCR switch
on remote control repeatedly until the [Vcfi] symbol
appears in the VCR front panel.
3. Select the VCR output channel (3 or 4) at the TV. If you
have connected your VCR to the A/V input jacks on the
TV, you should select the A/V source at the TV for
improved picture performance.
4. Select channel to be watched at VCR. If you have a
cable box, select the cable box output channel (usually
3 or 4) at the VCR. Cable box channels are selected at
the cable box.
Camcorder Is Connected to VCR
Front AJV Jacks on Stereo VCR
A/V cable is not provided with VCR.
TURN OFF POWER OR UNPLUG VCR
BEFORE MAKING ANY CONNECTIONS
Select AUX Channel on VCR for Viewing
1.
Turn TV and VCR on.
9. Place VCR in VCR mode by pressing TV/VCR switch
on remote control repeatedly until the [_ symbol
appears in the VCR front panel.
3. Select the VCR output channel (3 or 4) at the TV. If you
have connected your VCR to the A/V input jacks on the
TV, you should select the A/V source at the TV for
improved picture performance.
4, Select
AUX channel at "v'CR by using Channel
Up/Down to select the next channel after the highest or
lowest channel programmed in the VCR.
NOTE: Equipment connected to the front Audio/Video
(A/V) jacks on the VCR has operational priority over equip-
ment connected to the rear A/V jacks.
23