Watching Tv Through The Vcr - Zenith VRB210 Operating Manual

P A G E 2 0 O P E R AT I O N

Watching TV Through the VCR

This page shows a typical video system and explains how to select channels.
All-Channel
Cable TV
Wall Jack
Direct Cable
Typical
Cable Box
From
Cable- TV IN OUT
System
CH3 CH4
Selecting Channels when the VCR is OFF
1. Turn TV on.
2. Select channel you'd like to watch at the TV. If you have
a cable box, select channel 3 or 4 at the TV. Select cable
box channels at the cable box.
Selecting Channels at the TV when VCR is ON
1. Turn TV and VCR on.
2. Place VCR in TV mode by pressing the TV/VCR button on
the remote control repeatedly until the VCR indicator
disappears from the front panel of the VCR.
3. Select channel you'd like to watch at the TV. If you have
a cable box, select channel 3 or 4 at the TV. Select cable
box channels at the cable box.
Antenna
Or
Zenith Stereo VCR
OUT
VHF/UHF/CATV
Or
Cable Box
IN
Output
to VCR
CHANNEL
3 4
VCR Output to TV
(Channel 3 or 4 when
AUDIO VIDEO
VCR is on and TV/VCR
OUT OUT
is in VCR position)
R L
Audio/Video Output to TV
Selecting Channels at the VCR when VCR is ON
1. Turn TV and VCR on.
2. Place VCR in VCR mode by pressing the TV/VCR button on
the remote control repeatedly until the VCR indicator
appears in the front panel of the VCR.
3. Select channels 3 or 4 at the TV. If your TV is equipped
with A/V input jacks, check your TV operating manual to
select the A/V source for a better picture.
4. Select the channel you'd like to watch at the VCR. If you
have a cable box, select channel 3 or 4 at the VCR.
Select cable box channels at the cable box.
Zenith TV
VHF-UHF
CABLE IN
VIDEO AUDIO
IN IN
L R