Zenith IQB27B44 Operating Manual & Warranty page 46

Use Auto Find to automatically search and try all possible brand codes
L
F
IlL
[]
Turn on the device you want the remote to control..
Pressand hotd PRGuntil, the indicator l,ight turns on,
then rel,easePRG.
Pressthe key for the device you are trying to program
(CABLE,VCR,AUX, TV).
Press0-0-0 (zero-zero-zero), then press ENTER right away.
Aim the remote at the correct device and push the POWER
key (The indicator tight wil,l,turn off whil,e the POWER key is
pressed). Atl,owa secondto pass, then push the POWER key
again. Repeat until, the device turns off.
Push ENTER to save the code (The indicator l,ight wil,l,flash 3
times and then turn off).
Press POWER to turn the device back on.
Youcan quicklyget out of Auto Find by pressing PRG.
If the indicator light stays on while you pressPowerinstead of turn-
ing o_f,all the codeshave been tried and your device can't be con-
trolled.
O
AUTOFIND Anotherway of finding a brand code for controtlingauxiliaryequipment such as a VCR,DVDplayer,etc. that is
not avaiLablethrough the reguLarremote brand codeprogramming method.
PAGE 46 2o_