Table of Contents
Advertisement
Set up your remote control to operate other brand name devices
Turn on the deviceyou want to program.
On the chart on page 46/47, find the type of deviceyou're
programming, and then find the brand name. Make a note of
the three-number code,you'LLneed it soon.
Pressand hold PRG.It's recessedso it doesn't get pushed
accidentally.Use a small, blunt object. Whenthe indicator
Light turns on, you can releasePRG.
Push the key name with the type of device you're program-
ming (MCR,CABLE,AUX, TV).
Using the NUMBERkeypad, enter the three-number code you
found on page 46/47.
Press ENTER to save the code. (The indicator Lightwill flash
3 times, then turn off to indicate the code is valid.)
Point the remote at the device and push POWER. It should
turn off. If not, try the other codesListed and continuefrom
step three.
Note: To reset remote to factory settings, enter g-1-1, in
Step 5.
Note: After programming, be sureto pressthe mode key
first to operate the device you have just programmed.
[]
Programming your Zenith remote may allow you to use one remote
to workup to 7 different devices.
]
Not all devices will work with your Zenith remote control.
PROGRAMMING
PRG
DEVICE
Procedureto set up remote to operate other equipment.
Programming mode key.
Infra-red remote controUabte electronic accessoryequipment.
2o_
PAGE
43
Advertisement
Table of Contents
