Installation Requirements; Tools And Parts; Location Requirements - Whirlpool ACE184XS0 Use & Care Manual

IMPORTANT SAFETY INSTRUCTIONS
WARN I NG:
To reduce the risk of fire, electrical shock or injury when using your air conditioner, follow these basic precautions:
• Plug into a grounded 3 prong outlet.
[] Do not remove ground prong.
[] Do not use an adapter.
[] Do not use an extension cord.
[] Unplug air conditioner before servicing.
[] Use two or more people to move and install air conditioner.
SAVE TH ESE INSTRUCTIONS
INSTALLATION REQUIREMENTS
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools Needed
• Flat-blade and Phillips
screwdrivers
• Level
• Socket wrench and 7/16"
and 1/4"sockets
• Pencil
• Scissors
• Tape measure
• Drill and ¾£' or smaller bit
• 1/4"nut driver
• Utility knife
Through-the-wall installation:
In addition to the tools listed above, the following tools are
needed for though-the-wall installation.
• Saw • 1" (2.5 cm) or thicker
lumber
• Wood preservative
• Caulk • 7-#10xl"woodscrews
NOTE: Installation parts are supplied for double-hung windows
up to 40" (101.6 cm) wide. A special Wide Window Kit is available
from your dealer or service center. See "Accessories."
IMPORTANT: Observe all governing codes and ordinances.
Check the location where air conditioner will be installed. Proper
installation is your responsibility. Make sure you have everything
necessary for correct installation.
The location should provide:
• Grounded electrical outlet within 4 ft (122 cm) of where the
power cord exits the air conditioner.
NOTE: Do not use an extension cord.
• Free movement of air in room to be cooled.
• A large enough opening for the air conditioner.
• Adequate wall support for weight of air conditioner. Air
conditioner weighs between 145 and 200 Ibs (65 to 96 kg).
NOTES: Cabinet louvers must not be obstructed. Air must be
able to pass freely through the cabinet louvers.
Parts supplied (on some models)
Check that all parts are included in parts package.
E F
A _i/¸¸
A. Cabinet louvers
M N 0 P
A. Window-lock G. Lock washers (6) M. #8 x ½" hex-head
bracket H. Angle supports (2) metal screws (4)
B. Filler board L 2 _" (6.4 cm) seal strip N. # 10 x _" round-head
C. Vertical supports (2) j. Foam seals for air wood screws (3)
D. Foam blocks (4) conditioner (3) O. #8 - 18 x _" round-
E. Nuts (6) K. Foam window sash head screws (2)
F. Flat washers (6) seal t_ _" round-head
L. Window rail seal bolts (6)