Table of Contents
Advertisement
Load clothes l oosely i ntothedryer. Donotpack thedryer. Allow
space f orclothes t otumble f reely. The following c hart s hows
examples ofbalanced loads thatwould allow forproper tumbling.
Heavy w ork
3 pairofpants, 4 pairofjeans, 2 pair o f
clothes
overalls, 3 shirts
Delicates
3 camisoles, 1robe, 4 slips,
6 undergarments,
2sets ofsleepwear,
1child's o utfit
Towels
10bath towels, 10hand towels, 14wash
cloths, 1bathmat
Mixed Load
3 double s heets, 4pillowcases,
8 T-shirts, 6 pairofshorts, 2blouses,
8 handkerchiefs
• Useanoheat ( air) s etting forrubber, plastic o rheat s ensitive
fabrics.
• Line drybonded o rlaminated fabrics.
Ifyouareunsure o fthetemperature
toselect foraload, s elect
thelower s etting rather than thehigher setting
NOTE: Ifyouhave questions about drying temperatures
for
various loads, refer t othecare label d irections.
CYCLE DESCRIPTIONS
Press
and o(d
2 seconds
to set.
Select the correct cycle and temperature for your load.
Dryer tips
•
Press firmly in the center of the pad.
•
The indicator light next to the pad will light up when a
selection is valid.
•
A short tone will sound when a selection is valid•
•
Three short tones will sound when a selection is not valid.
•
After your first use, your dryer "remembers"
the Dryness
level, WRINKLE SHIELD
TM
setting and End of Cycle Signal
setting you selected.
•
If you press and hold the pad with either the Temperature
selector, the End of Cycle Signal selector or the More Dry or
Less Dry arrows, you will advance the settings•
•
If you press and hold the Less Time or More Time arrows in
the Timed Cycles, the time will advance in five minute
intervals•
Drying tips
•
Follow care label directions when they are available.
•
If you use fabric softener sheets, use only ones labeled as
"dryer safe." Follow package instructions.
•
Remove the load from the dryer as soon as tumbling stops to
reduce wrinkling. This is especially important for permanent
press, knits, and synthetic fabrics•
•
Cool Down tumbles the load without heat during the last few
minutes of all cycles. Cool Down makes the loads easier to
handle.
Cycle tips
•
Use the Timed Dry cycle with the Air Only (no heat)
Temperature setting for rubber, plastic or heat sensitive
fabrics.
Temperature
tips
If your dryer has multiple heat settings:
•
Use a high heat setting for drying heavyweight
items such as
towels and work clothes.
•
Use a medium heat setting for drying medium-weight
items
such as sheets, underwear, permanent press fabrics, and
some knits.
•
Use a low heat setting for drying lightweight items such as
lingerie, blouses, dresses, and some knits.
Timed
Ol _
Use your Automatic
Cycles to dry most loads. Your dryer uses
the SENSEON
TM
Drying System. Electronic sensors measure the
temperature of the exhaust to increase or decrease drying
temperatures for faster reaction time and tighter temperature
control. Your two most frequently used cycles, Heavy Duty and
Normal, are enhanced with the SENSEON system to provide the
shortest drying time.
After drying a load in any of the Automatic
Cycles, check the
dryness.
•
If the load is drier than you like, press the down arrow to
select a setting closer to Less Dry the next time you dry a
similar load.
•
If a load is not as dry as you like, complete drying using a
Timed cycle. Press the Up arrow to select a setting closer to
More Dry the next time you dry a similar load.
NOTE: The Up and Down arrows are located next to the
Automatic Cycles pads.
To use the Automatic
Cycles
1. Press the desired AUTOMATIC CYCLES pad.
2. Press the Up or Down arrows to select from five levels of
More Dry or Less Dry, if desired.
3. Select the WRINKLE SHIELD
TM
setting, if desired.
4. Press the Bell symbol to select the End of Cycle Signal
Volume.
5. Press START.
NOTE: The Estimated drying time varies from the actual drying
time with an Automatic cycle. The type of fabric, size of the load,
and the dryness selected affect drying time. See "Drying, Cycle
and Temperature tips."
Advertisement
Table of Contents
