Stopping And Restarting; Loading Clothes; Drying, Cycle And Temperature Tips; Cycle Descriptions - Whirlpool LGR4634JQ2 Use & Care Manual

Stopping and Restarting
You can stop your dryer anytime during a cycle.
To stop your dryer
Open the dryer door or turn the Cycle Control knob to OFE
NOTE: The Cycle Control knob should point to an Off area
when the dryer is not in use.
To restart your dryer
1. Close the door.
2. Select a new cycle and temperature (if desired).
3. Push START.
,a ng Clothes
Load clothes loosely into the dryer. Do not pack the dryer.
Allow space for clothes to tumble freely. The chart
following shows examples of balanced toads that would
allow for proper tumbling.
Heavy work 3 pair of pants, 4 pair of jeans, 2 pair of
clothes overalls, 3 shirts
Delicates 3 camisoles, 1 robe, 4 slips,
6 undergarments, 2 sets of sleepwear,
1 child's outfit
Towels 10 bath towels, 10 hand towels, 14
wash cloths, 1 bath mat
Mixed Load 3 double sheets, 4 pillowcases,
8 T-shirts, 6 pair of shorts, 2 blouses
8 handkerchiefs
Cycle tips
• Dry most loads using the Energy Preferred Automati
setting ( * ).
• Use the no heat (air) cycle (if available) for rubber,
plastic or heat sensitive fabrics.
Temperature tips
If your dryer has multiple heat settings:
• Use a high heat setting for drying heavyweight item_
such as towels and work clothes.
• Use a medium heat setting for drying medium-weigI
items such as sheets, underwear, permanent press
fabrics, and some knits.
Use a low heat setting for drying lightweight items st
as lingerie, blouses, dresses, and some knits.
Use a no heat (air) setting for rubber, plastic or heat
sensitive fabrics.
• Line dry bonded or laminated fabrics.
If you are unsure of the temperature to select for a Ioa¢
select the lower setting rather than the higher setting
NOTE= If you have questions about drying temperature
for various loads, refer to the care label directions.
Cycle Descriptions
Yourmodel may vary from the model shown.
Timed Drying 40
) _
AccuDry
_ns_ D_g
60
70
Drying, Cyde and
Temperature Tips
Select the correct cycle and temperature for your toad.
The Cycle Control knob does not move until the load is
almost dry. After Cool-Down, the knob automatically turns
to Off and tumbling stops.
Coot-Down tumbles the load without heat during the last
few minutes of all cycles. Cool-Down makes the loads
easier to handle.
Drying tips
• Follow care label directions when they are available.
• If you use fabric softener sheets, use only ones labeled
as "dryer safe." Follow package instructions.
• Remove the load from the dryer as soon as tumbling
stops to reduce wrinkling. This is especially important
for permanent press, knits, and synthetic fabrics.
off
Less
Dry
Dow_
90Minute 30Minute
{o_on) Off Io_]
Cycle Control knob
_1_En_gy Prefer
Automat_
Automatic cycle(s)
Use your Automatic cycle to dry most loads. Your dry(
uses either the electronic ACCUDRY" system or the
Automatic Dry control. The control senses the moistu_
level in the load and shuts off when the load reaches 1
selected dryness.
On some models
• Automatic Dry (High Heat) and (Low Heat)
Select the temperature by moving the Cycle Contl
knob to (High Heat) for bigger or heavier loads or
Heat) for smaller or lighter loads.
'.]
8