Table of Contents
Advertisement
Troubleshooting
Matters
Cannot use the
flash.
Flash
The playback
image is dark
even though the
flash was used.
The image is
Photographed images
blurred.
Photographed
Recording images
images are not
recorded.
220
Problems
Possible causes
The shutter button was pressed while the
flash was charging.
The flash is set to suppressed flash mode.
(The flash is closed.)
The battery has run out.
The subject is too far away.
Your finger was covering the flash.
The lens is dirty.
M (Manual) was set for the focus mode
when the picture was taken.
The shutter speed was slow when the
picture was taken.
AC power adapter was connected or
disconnected during turning the camera
on.
Solutions
Wait until the charging is completed before
pressing the shutter button.
Raise the built-in flash.
Charge the battery or load fully charged
battery.
Move to within the effective flash range
before taking the picture.
Hold the camera correctly.
Clean the lens.
Set S (Single-servo AF) or C(Continuous-
servo AF) for the focus mode. Or make
sharp focus using M (Manual) before
taking a picture.
It may cause camera shake. Hold the
camera steadily.
Connect or disconnect the AC power
adapter only when the camera is off.
Failing to turn the camera off first can
result in damage to the memory card or
malfunctions during PC connection.
Page
79
79
30,
32,
208
81
48
203
54, 60
–
210
Advertisement
Table of Contents
