FujiFilm IS Pro Owner's Manual page 147

2
Enter a comment.
INPUT COMMENT INPUT COMMENT
1234567890_ABCDEFGHIJKLMNOP 1234567890_ABCDEFGHIJKLMNOP
QRSTUVWXYZ!"#$%&'()*+,->/:;< QRSTUVWXYZ!"#$%&'()*+,->/:;<
= > ? @ [ ] { } = > ? @ [ ] { }
DONE DONE DELETE DELETE
A Rotate the main-command dial to display
the desired first letter to enter.
B Press q to enter the second letter.
MEMO
• Repeat the steps A-B to enter more letters.
• Press p or q to select the letter to delete, then press
n to delete.
• To insert a letter between other letters, press p or q
to select the letter after the inserting position, then press
o to insert.
3
Exit from [IMAGE COMMENT].
Press MENU/OK.
INSERT INSERT
How to use the SET UP menu (➝p.138)
BARCODE READER/GPS
Store information from a barcode reader or GPS
connected to a 10-pin terminal as Exif information.
[BCR 1 SHOT]
Read barcode information for each shot and store it as
comment information. Pictures cannot be taken without
reading a new barcode.
[BCR CONTINUOUS]
Store registered barcode information as comment
information in every file. To erase the registered
information, read the "barcode eraser" on this page or
delete the letters registered in the [IMAGE
COMMENT].
[GPS]
Store information from GPS device allowing latitude,
longitude, altitude and UTC (standard universal
coordinated time) to be recorded with photographs.
[OFF]
No store barcord or GPS information is retrieved.
MEMO
• When the barcode information is stored,
displayed in the control panel.
• The following ASCII characters can be used for the
barcode information:
(space), 0~9, _(under bar), A~Z (lower-case characters
can be entered using barcode reader, however they
cannot be reviewed or edited on the [INPUT
COMMENT] screen.), ! " # $ % & ' ( ) * + - . / : ; < = > ?
@ [ ] { }.
Usable types of barcode depend on the specifications
of the barcode reader.
BCD
is
Continued Q
147