Foxconn 755FXK8AA series User Manual page 23

Front Panel Connector: FP1
This motherboard includes one connector for con-
necting the front panel switch and LED indicator.
Hard Disk LED Connector (IDE_LED)
Attach the connector to the IDE_LED on the front panel of the case; the LED will
flash while the HDD is in operation.
Reset Switch (RESET)
Attach the connector to the Reset switch on the front panel of the case; the
system will restart when the switch is pressed.
Power LED Connector (P_LED)
Attach the connector to the Power LED on the front panel of the case. The Power
LED indicates the power supply status. When the system is in S0 status, the
LED is on. When the system is in S1 status, the LED is blink. When the system
is in S3, S4, S5 status, the LED is off.
Power Switch Connector (PWRBTN#)
Attach the connector to the power button of the case. Pushing this switch allows
the system to be turned on and off rather than using the power supply button.
USB Connectors: F_USB 1, F_USB 2
Besides four USB ports on the rear panel, the series
of motherboards also have two 10-pin connectors
on board which may connect to the front panel USB
cable to provide additional four USB ports.
IrDA Connector: IR
The IrDA infrared transmission allows your com-
puter to send and receive data via an infrared ray.
The relevant parameters for the BIOS Integrated
Peripherals should be set prior to using this
function.
1394 Connector (optional): F_1394
The 1394 expansion cable can be connected to ei-
ther the front (provided that the front panel of your
chassis is equipped with the appropriate interface)
or the rear panel of the chassis.
15
Chapter 2 Installation Instructions
IDE_LED
RESET
NC
VCC
GND
Empty
TPA+
GND
TPB+
+12V
2005-2-3, 14:33
1
PLED
PWRBTN#
FP
FP1!
1 2
VCC
D0-
D1-
D1+
D0+
GND
NC
9 10
F_USB1/2
+5V
Empty
IRRX
GND
IRTX
IR
1 2
TPA-
GND
TPB-
+12V
GND
9 10
F_1394
15