Table of Contents
Advertisement
Connect the Drain Hose
Proper connection of the drain hose protects your floors from
damage due to water leakage. Carefully read and follow these
instructions.
The drain hose is connected to your washer and is stored inside
of the washer cabinet.
Remove
drain hose from washer
cabinet
Gently pull the corrugated drain hose out of the washer from the
top of the hose. Continue to pull the hose until the end emerges.
Do not force excess drain hose back into the rear of the washer.
Laundry
tub drain
or standpipe
drain
Connecting
the drain
hose "hook"
to the corrugated
drain
hose
1. Open the yellow single-wire clamp and slide over the end of
the drain hose about 4 in. (10.2 cm) (Pliers optional.)
2. Wet the outside end of the drain hose with tap water. Do not
use any other lubricant.
3. Twist and push the "hook" back and forth while pushing
down onto the drain hose. Continue until the "hook" is down
to the enlarged diameter of the drain hose.
4. Open the yellow single-wire clamp (placed on the drain hose
earlier) and slide over the base of the drain hose "hook" to
secure the sections together. (Pliers optional.)
5.
Put hooked end of drain hose into laundry tub or standpipe.
Rotate "hook" to eliminate kinks.
Connect the Inlet Hoses
1. Insert a new flat washer (supplied) into each end of the inlet
hoses. Firmly seat the washers in the couplings.
I. Coupling
2. Washer
1.
0
2.
Connect
the inlet hoses to the water faucets
Make sure the washer basket is empty.
2. Attach the hose with the red coupling to the hot water faucet.
Screw on coupling by hand until seated on the washer.
3. Attach the hose with the blue coupling to the cold water
faucet. Screw on coupling by hand until seated on the
washer.
4.
Using pliers, tighten the couplings with an additional two-
thirds turn.
NOTE: Do not overtighten. Damage to the valves can result.
Clear the water lines
5.
Run water through both faucets and inlet hoses, into a bucket
or laundry tub, to get rid of particles in the water lines that
might clog the inlet valve screens.
Connect the inlet hoses to the washer
6.
Attach the hose with the blue coupling to the COLD (left) inlet
valve. Screw on coupling by hand until seated on the washer.
Using pliers, tighten the couplings with an additional two-
thirds turn.
NOTE: Do not overtighten. Damage to the valves can result.
To prevent drain water from going back into the washer:
•
Do not straighten
hooked end of the drain hose and force
excess drain hose into standpipe.
Hose should be secure but
loose enough to provide a gap for air.
•
Do not lay excess hose on the bottom of the laundry tub.
Floor drain
Do not install the drain hose "hook" on to the corrugated drain
hose. You may need additional
parts. (See Floor Drain under
"Alternate Parts You May Need.")
I. Cold water inlet valve (blue)
2. Hot water inlet valve (red)
7. Attach the hose with the red coupling to the HOT water (right)
inlet valve. Screw on coupling by hand until seated on the
washer. Using pliers, tighten the couplings with an additional
two-thirds
turn.
NOTE: Do not overtighten, Damage to the valves can result.
7
Advertisement
Table of Contents
