Weslo PURSUIT E25 User Manual page 8

BATTERY INSTALLATION HOW TO OPERATE THE CONSOLE
Before the console can be operated, two AA batteries
must be installed. Refer to step 7 on page 6 for battery
installation instructions.
DESCRIPTION OF THE CONSOLE
i.I
SCAN TIMER SPEED
DISTANCE CALORIES
PULSE
The console features six modes that provide instant
exercise feedback while you pedal:
• Scan--This mode displays the timer, speed, distance,
calories, and pulse modes, for a few seconds each, in
a repeating cycle.
• Timer--This mode displays the elapsed time. Note: If
you stop pedaling for a few seconds, the time mode
will pause and a stop symbol will appear in the dis-
play.
• Speed--This mode displays your pedaling speed, in
miles per hour.
• Distance--This mode displays the total distance that
you have pedaled, in miles.
• Calories--This mode displays the approximate num-
ber of calories you have burned.
• Pulse--This mode displays your heart rate when you
use the pulse sensor.
Note: If there is a thin sheet of clear plastic on the
display, remove it.
1. Turn on the console.
To turn on the console, press the mode button or
simply begin pedaling. The entire display will
appear for two seconds; the console will then be
ready for use.
2. Select one of the six modes:
Scan mode--
When the con-
sole is turned on,
the scan mode
will be selected.
The SCAN indi-
cator will show
that the scan Mode Indicators
mode is selected,
and a second
mode indicator will show which mode is currently
displayed. Note: If you have selected a different
mode, you can select the scan mode by repeatedly
pressing the mode button until the SCAN indicator
reappears.
Timer, speed,
distance, calo-
ries, or pulse
mode--To select
one of these
modes for contin- _ /
uous
display,
SCAN TIMER SPEED
DISTANCE CALORIES
press the mode PULSE
button repeatedly
until the desired
mode indicator appears. Make sure that the SCAN
indicator does not appear.
Note: To reset the display, press the mode button
for about two seconds. After the display is reset, the
scan mode will be selected.
3. Measure your heart rate if desired.
To measure
your heart rate,
first plug the
pulse sensor
wire into the
jack on the left
side of the con-
sole.
Pulse Sensor Wire