Weslo PURSUIT E25 User Manual page 5

2. Extend the Seat Frame (3) to the position shown.
Firmly tighten the Adjustment Knob (28) into the indi-
cated opening in the Right Side Shield (18).
3. Orient the Rear Stabilizer (9) so the caution decal is on
the left side, as shown. Attach the Rear Stabilizer to
the Seat Frame (3) with two M10 x 54mm Zinc
Carriage Bolts (49) and two M10 Zinc Nylon Locknuts
(61).
Orient a Hand Weight Rack (4) as shown, and attach it
to the left side of the Rear Stabilizer (9) with two M4 x
16mm Screws (59). Attach the other Hand Weight
Rack in the same way. Note: If the Hand Weight Racks
are not oriented correctly, they will not support the
Hand Weights (not shown).
Set the six Hand Weights (not shown) on the Hand
Weight Racks (4) as shown on page 3.
4. Slide a Handlebar (7) onto one side of the Seat Frame
(3). Attach the Handlebar with two M6 x 36mm Zinc
Button Bolts (52) and two M6 Zinc Nylon Locknuts (53).
Attach the other Handlebar (7) to the Seat Frame (3) in
the same way.
5. Attach the Backrest Frame (5) to the Seat Frame (3)
with an M10 x 136mm Zinc Bolt (51) and an M10 Zinc
Nylon Locknut (61).
Raise the Backrest Frame (5) until it is nearly vertical.
Insert the Adjustment Pin (55) into the pin hole in the
Backrest Frame and the pin hole in the Seat Frame (3).
Attach the Backrest (10) to the Backrest Frame (5)
with four M6 x 16mm Zinc Screws (57).
3
28
49
61
10
\
5
57
51
57
3 r 55