Replacing Oven Lights - Viking VDSC5364GSS Use & Care Manual

Self-Clean Cycle
Replacing Oven Lights
To start the Self-Clean cycle:
1. Close the door completely,
2. Turn the oven selector knob clockwise to the "SELF CLEAN" mode,
3. Turn the temperature control knob past the clean setting until the
knob stops. At this time, the clean indicator liaht will come on.
Within 30 seconds the automatic door latch engages and the oven
indicator light comes on, The oven ineicator light will remain on
until the oven reaches the self-clean temperature and will then cycle
on and off during the self-clean cycle When the oven reacqes the
elevated temperature needed for self-clean, the door lock indicator
ight comes on.
ELECTRICAL SHOCK HAZARD
Disconnect the electric power at the main fuse or circuit
breaker before replacing bulb.
4. The door lock indicator light will remain on until the self-clean is DO NOT touch bulb with bare hands. Clean off any signs of oil from
completed or interrupted and the oven temperature drops to a safe the bulb and handle with a soft cloth.
temperature. A complete cycle is approximately 3-1/2 hours with an
additional 30 minutes needed for the oven to cool down enough glass light
for the door latch to disengage. 1. Unsnap glass light cover _ cover
using a screwdriver in the
Note; A fan noise will be heard during the self-clean cycle and will access groove.
continue to run for the 3-1/2 hour duration of the self-clean cycle.
access
2. Firmly grasp light bulb and groove
5. When the cycle is completed, turn both the oven selector and pull out. '........... ___z_____-_J
temperature control knob to the "OFF" position. When the oven
has completely cooled, open door and remove any ash from the
oven surfaces with a damp cloth.
To stop the Self:Clean cycle:
To cancel or interrupt the self-cleaning cycle, turn both the
temperature control knob and the oven function selector knob _o
"OFF". When the oven temoerature drops to a safe temperature, the
automatic door latch will release and the oven coor can be opened.
When the oven has completely cooled, remove any ash from the oven
surfaces with a damp sponge or cloth ......
3. Replace with halogen bulb
using volt and wattage _--}_ _ I
requirements listed on glass ,light
cover. Du D
4. Replace the light cover by __ . _" 11
snapping glass cover onto _ ml_ c_ I
metal box.
5, fTsCTonrneCrtcPtbejTktJr!e main _,
50 51