Table of Contents
Advertisement
3.
Selecting alarm: Turn Shuttle knob to select desired camera to configure. Selected camera
number will be highlighted by a blue frame. See above image.
4.
Enter time bar editing mode: turn Jog knob to switch to time bar editing mode. When this mode
is selected, all 9 time bars will be highlighted within a blue frame.
5.
Select desired time bar for setting: press Enter button, the first time bar will be selected for
setting and highlighted in a red frame. See below image. Press Jog to switch to desired time bar for
setting.
6.
Editing blocks in a time bar: when a time bar is selected (highlighted in red frame), press Enter
button, then the first block of this bar will be selected (highlighted in blue frame). Turning Jog knob to
switch to desired block as starting time, and press Enter button again to confirm. At this time, the
current and all following blocks will turn into gray, which means this gray timezone has been set to the
recording mode of gray (Alarm Action off). User can also change the timezone to a different record
mode by following instructions in the next step.
74
Advertisement
Table of Contents
