Controlling The Tv Or The Av Receiver (Amplifier); With The Supplied Remote - Sony DVP-S530D Operating Instructions Manual

Controlling the TV or the AV Receiver (Amplifier) with the Supplied Remote
U_
e
i
i
When you set the TV/DVD,RECEIVER switch to TV, you
can control your TV using the keys below.
TV/
DVDeRECEIVER
switch
ENTER
Controlling an AV receiver (amplifier)
with the remote
By pressing You ran
I/_ (POWER) Turn the TV on or off
TV/VIDEO Select the input source for the TV
VOL Adjust the volume of the TV
TV CH Change the channel of the TV
Number buttons Select the channel of the TV
and ENTER
Note
Depending on the TV, you may not be able to control your TV or
to use some of the buttons above,
1 Slide the TV/DVD,RECEIVER switch to
POWER) DVD,RECEIVER.
2 Hold down I/_ (POWER), and enter your AV
receiver's manufacturer's code (see the table
below) using the number buttons. Then release
I/(_) (POWER).
Manufacturer Code number
Sony 91(default), 88,
89
Denon 84, 85, 86
Kenwood 92, 93
Onkyo 81, 82, 83
Pioneer 99
Sunsui 87
Technics 97, 98
Yamaha 94, 95, 96
- 90*
* By setting the code number 90, you can adjust
the volume of the TV even if the TV/
DVD.RECEIVER switch is on the
DVD°RECEIVER side, if you do not control an
AV receiver (amplifier) with the remote.
Code numbers of controllable receivers
(amplifiers)
If more than one code number is listed, try entering them
one at a time until you find the one that works with your
receiver (amplifer).
You can also change the sound volume of the AV receiver
(amplifier) using VOL.
54
Note
Depending on the AV receiver (amplifier), you may not be able to
control your AV receiver (amplifier).