Chute - Craftsman 247.885550 Owner's Manual

,=,= i= ,, = =,, ,=,,H ,,, ,=,,,,,,i,, ,
ASSEMBLY INSTRUCTBONS
, i11,,,1 H 1111 l=,,,r = , 1],,_1,1 i
HOWTOSET-UPYOURSNOWTHROWER
Bolt 1-3/4"
Long
FIGURE 1.
WARNING: MAKE CERTAIN THE
_ SPARK PLUG WIRE IS DISCONNECTED
AND MOVED AWAY FROM THE SPARK
PLUG BEFORE ASSEMBLING THE
SNOW THROWER.
Cupped
Washer Hex
Jut
O
ATTACHING THE HANDLE ASSEMBLY
(Hardware A)
® Stretch out control cables and place on the floor.
® Place right handle in position with fiat side against
the snow thrower,r Secure bottom holes in handle
to snow thrower using hex bolts 5/8" long and lock
washers. See figure 1. Do not tighten at this time.
PIace handle tabs over the upper holes in handle,
so the curve in the handle tab matches the curve in
the handles. Secure to the snow thrower using hex
bolts 1-3/4" long and lock washers Do not tighten
at this time.
e Attach the left handle in the same manner, Do not
tighten at this time
e Place the handle panel in position between the
handles, Secure with four carriage botts, cupped
washers (cupped side against the handle panel)
and hex nuts as shown in figure 2.
Tighten the four hex bolts used to attach the bot-
tom of the handles to the snow thrower frame.
O
FIGURE 2,
Carriage
Bolt
FIGURE 3.
, Assembly
Hex Bolt
Hex Lock Nut
Chute Flange
Keeper
ATTACHING THE CHUTE ASSEMBLY
(Hardware B)
e Grease the chute opening using a multi-purpose
automotive grease or equivalent.
• Place chute assembly over chute opening, with the
opening in the chute assembly facing the front of
the unit, Place chute flange keepers beneath lip of
chute assembly. Insert hex bolt up through chute
flange keeper and chute assembly as shown in
-_----figure 3. Secure with hex lock nut,, After assembling
all three chute flange keepers, tighten then back off
1/4 turn to allow easier movement_
6